Call us: 509-452-3279

Your Smile Away From Dental Cavities

How to Repair a Leaking Grants Pass Radiator

Regarded as one of the most neglected units in a vehicle is the engine cooling system or radiator. More than ever, it is a significant component in the modern day, high-efficiency engines. You may already know this, but the primary function of the cooling unit is to whisk away the heat that is created due to fuel combustion, coming from the engine block and cylinder head.

No doubt, the coolant, or water, within the radiator need to be circulated. Back in the day, all a vehicle owner had to do is ensure the radiator cap fitted tightly, ensure there is enough coolant in the radiator and drove off. Nowadays, the more modern vehicle is equipped with sealed systems, so that car owners have no need to worry until a year later when they book their vehicle for a service at a local Grants Pass Radiator repair and service center.

However, you are dealing with more than just a radiator. Other parts include a cap and hoses to ensure a properly functioning cooling unit. Then you have components such as a coolant temperature sensor, water pump, and thermostat that also deserves attention.

Do not forget the radiator fan. Older vehicles had the fan hooked up to the water pump drive assembly, whereas modern cars would be equipped with an electrically-driven fan.

You might be able to drive around with a leaky radiator cap or faulty temperature sensor, but you dare not try and do this when you have a blown water pump as it will most certainly damage the engine within minutes. The same would happen should an electrically-driven fan quit.

A regular occurrence in older vehicles seems to be leaking coolant hoses. These are usually cheaper and easier to repair, but still important to take care off as it may result in extensive damage if neglected. If your car loses too much coolant and is unable to cool itself, then you will in all likelihood be saddled with an expensive repair bill to replace the engine if not seen to immediately.

What You Must Do to Fix a Leaky Radiator Hose
If you are ever in a situation where you cannot shut the car off instantly due to a leaking radiator hose, then just monitor the temperature gauge as best you can to ensure the engine does not overheat. Once the temperature soars too high, you simply have to shut off the vehicle right away.

The best way to diagnose such issues would be visually by looking to see if there are any coolant dripping beneath your car or to look for signs of a puddle on the ground underneath your vehicle.

When searching for radiator shops near me, remember

Also, during a minor leak you may notice only a little bit of smoke and at times an unusual smell coming from the antifreeze, like a kind of sweet, maple syrup smell. Should the coolant be completely gone out of the engine, do not even think about cranking it up as the cooling until will start heating up within seconds.

Here is how reputed Grants Pass Radiator repair centers would take care of the problem:

  1. First, they would shut the engine down.
  2. Ensure any remaining coolant is allowed enough time to cool down.
  3. In case there is no sure way of telling where the leak originates from, the radiator would be filled with water to inspect it for leaks.
  4. Locate the leaky radiator hose.
  5. Put a bucket or pan under it catch any dripping coolant.
  6. Make use of a set of pliers or screwdriver, depending on the type of clamps used to slide the clamps on the hose.
  7. Take the leaky hose off as well as the old clamps so these can be slid back onto the new radiator hose.
  8. Put the new radiator hose onto the fittings before tightening the clamps.
  9. Refill the coolant reservoir and radiator to the recommended levels using a 50/50 mixture of antifreeze and water. It is best to use coolant without water.
  10. Start the car and run the motor to warm the engine up while ensuring the radiator cap is off.
  11. Keep the motor running, so both the lower and upper hoses heat up thereby ensuring the thermostat remains open and the coolant flows throughout the entire unit.
  12. Add more coolant as needed.
  13. Lastly, take a look under and inside the engine compartment to see if there are any leaks. Also, inspect the ends of the radiator hose for dampness or leaking before placing the radiator cap on again.

The vehicle’s radiator serves as the primary cooling component. It is crucial for it to remain in a good working condition. The moment you notice any signs of radiator failure, speak to your Grants Pass Radiator technicians before it turns into a costly replacement. Ask more about the advice from Medford Radiator Service, radiator repair.

Tags: , , , ,

Related posts

Leave a Comment

Leave a Reply

Your email address will not be published.